Home > Shop by Size >

SanSiro VTASL67 Freestanding 67 Inch Heated Air Jetted Single Slipper Tub with Drain and Concealed Blower
SanSiro VTASL67 67in Freestanding 67 inch Air Jetted Single Slipper Tub
 
Alternative Views:

Made in the USA

Handheld remote control activated variable speed blower
There is a deck area on this tub that can fit many vintage style faucets
Ultra-Quiet heated variable speed air blower located inside pedestal base
Heated blower to increase air bubble temperature
When the bubbles enter the water, even though they are warm, they will feel slightly cool to the skin
Blower is equipped with two Anti-back flow devices as per UL requirements
Requires a dedicated 15amp - 110v GFCI
12 individual flat face white air injectors in tub floor
Three foot of electrical cable plus 3' UL approved extension
Package includes tub drain in your choice of color
Slip resistant floor


MA Code Accepted

Specification Sheet
Installation Manual
Your Price: $2,595.00



Availability:: Usually ships in 3 to 4 weeks
Product Code: VTASL67


SS Overflow and Drain Finish*: 		Chrome
Brushed Nickel
Polished Nickel
Oil Rubbed Bronze
Don't supply a drain [Subtract -$35.00]

Ozone Sanitizing*: 		Don't add ozone sanitizing
Add Ozone Sanitizing [Add $175.00]

Tub Exterior Finish (Add 10 days)*: 		Leave tub as high gloss white finish (no extra time needed)
Paint tub exterior to match solid color details I will send [Add $385.00]
Aged Chrome [Add $599.00]
Aged Copper Leaf [Add $799.00]
Eggshell Matte Black [Add $385.00]
Description Electrical Cord 5'8" person inside tub
 
VTASL67 67" Heated Air Jetted Single Slipper Tub with Drain and Concealed Blower
Ready to plug in to a 15 amp 110 v GFCI
Photo here shows 67" version of the tub, proportions may change a little on different length tubs

Soothe away the aches of the day in a luxurious heated air jetted bathtub. We offer variable speed handheld remote control blower activation. The 12 individual flat face air injectors are placed on the bottom of the tub to massage calves and thighs. We use a heated blower to increase the ambient temperature of the bubbles 15 to 20 degrees within a period of around 2 minutes. Switching the air jetting on before entering the tub can be a good idea. While the air is heated, it can still feel slightly cool when the bubbles touch the skin, it will not feel hotter than the water in the tub.

Installation on this tub is very simple, everything needed is part of the tub. Simply connect the regular 3-pin plug to a 110v-15 amp GFCI and you're ready to go. The blower is inside the pedestal. In the unlikely event of a blower failure, replacing it is also very simple, just disconnect the electric and tub from the drain, turn it over and replace the blower, about a 30 minute job.
To maintain hygiene in the air pipes, every time you take a bath and drain the water, engage the blower for about 15 seconds to purge all residual water in the lines. Every three months, we recommend that you fill the tub about two inches over the highest jet with luke warm water and add a half cup of bleach. Engage the blower and let run for two minutes. Empty and repeat this step with clean water and purge the lines when the tub is empty.