SanSiro VTASL59 59" Heated Air Jetted Single Slipper Tub with Drain and Concealed Blower
Ready to plug in to a 15 amp 110 v GFCI
Photo here shows 67" version of the tub, proportions may change a little on different length tubs
away the aches of the day in a luxurious heated air jetted bathtub. We offer
variable speed handheld remote control blower activation. The 12 individual
flat face air injectors are placed on the bottom of the tub to massage calves
and thighs. We use a heated blower to increase the
ambient temperature of the bubbles 15 to 20 degrees within a period of around 2
minutes. Switching the air jetting on before entering the tub can be a good idea.
While the air is heated, it can still feel slightly cool when the bubbles touch
the skin, it will not feel hotter than the water in the tub.
Installation on this tub is very simple,
everything needed is part of the tub. Simply connect the regular 3-pin plug to
a 110v-15amp GFCI and you're ready to go. The blower is inside the pedestal. In
the unlikely event of a blower failure, replacing it is also very simple, just
disconnect the electric and tub from the drain, turn it over and replace the
blower, about a 30-minute job.
To maintain hygiene in the air pipes, every
time you take a bath and drain the water, engage the blower for about 15
seconds to purge all residual water in the lines. Every three months, we
recommend that you fill the tub about two inches over the highest jet with luke-warm
water and add a half cup of bleach. Engage the blower and let run for two
minutes. Empty and repeat this step with clean water and purge the lines when
the tub is empty.