SanSiro Eclipse-SM73CHS 73 x 35 inch Center Drain Variable Speed Water and Air Jetted Hydro-Spa Freestanding Acrylic Bathtub – Jetted Freestanding Tub

• Water Jetting
  Direction adjustment on four back, two hip and four foot jets.
• Water Speed Pressure and Control
Variable speed controller for water jets on tub deck.

• In-Line Heater
  The water jetting includes an in-line water heater that will maintain and even slightly increase the water temperature during jetting. The heater works automatically when the water runs through it.
• Air Jetting
  The air blower is fitted with variable speed control for total enjoyment. The twelve individual air injectors in the floor will bubble up around your legs, soothingly caressing your skin as they rise. Activating the air blower for about a minute before entering the tub can be a good idea for heating up the bubbles. While the air is warmed, it can still feel slightly cool when the bubbles first touch the skin. The sensation still feels fabulous. For additional hygiene, we recommend you activate the blower for 15 seconds after each bath to blow out any moisture trapped in the air lines.
• Chromotherapy
  For additional bathing relaxation, the system includes a seven color choice, mood enhancing chromotherapy underwater light.
• Ozone Sanitizing
  Ozone sanitizing is included with the hydro-spa jetting system. While the jetting tubes will drain very effectively, a little residual moisture retention is unavoidable. The ozone system, which only activates when the tub is jetting, will prevent bacteria build up. However, the regular maintenance suggested herein is a necessity for fully effective hygiene.
• Fittings Position
  The double shell tub design makes it possible to maintain the original bathtub appearance with no visible or remote jetting parts. All of the fittings are contained within the cavity in between the shells.
• Bath Salts and Bubble Bath
  It is safe to use bath salts and bubble bath. However, make sure the salts are dissolved before entering the bath or they can scratch the tub surface.
• Care and Maintenance
  Cleaning the high gloss acrylic finish requires a wipe down with a soft cloth and some very gentle liquid soap without abrasives.
• Recommended Regular Maintenance
  

  To maintain excellent hygiene, we strongly recommend the following preventative maintenance be carried out each 1-2 months.

  • Fill you tub with warm water to 2" above the top jet.
  • Add two cups of household bleach.
  • Activate all the jets on in the fully open position.
  • Allow the jets to run for 15 minutes.
  • Switch the jets off and allow the water to sit for 15 minutes.
  • Empty the tub.
  • Re-fill with fresh water, again 2" above the top jet.
  • Run the jets for 15 minutes.
  • Empty the tub and the job is finished.
  • If the tub is not in constant use, it is still very important to continue the maintenance as described herein.