 |
 |
 |
 |
SanSiro SS73A 73" HEATED AIR Massage Slipper Clawfoot Tub and Faucet Package with Chromotherapy - 14 jets Ready to plug in to a 15 amp 110 v GFCI
Made in the USA, this fabulous SanSiro air jetted clawfoot tub offering a delightfully relaxing sloped slipper back has all the fittings hidden between the inner and outer shells of the tub. The 14 individual air jets are strategically positioned along
the legs and at the back and feet for an all body soothing bubble massage. The double shell design of the tub makes it possible to maintain the original clawfoot tub appearance with all of the jetting features hidden in between the shells. the double shell feature also offers exceptional water heat retention. To keep the injected air bubbles as warm as possible, we equip the blower with a powerful heating element to pre-heat the injected air. This heater will raise the ambient temperature 15 to 20 degrees within a period of around 2 minutes, so switching the air jetting on before entering the tub can be a good idea. While not feeling just as cool, even heated air bubbles will feel a little cool when they make contact with the skin.
Care and Maintenance To remove most stains on the acrylic surfaces, it will only need to be wiped down with a soft cloth and some very gentle soap without abrasives.
To maintain hygiene in the air pipes, every time you take a bath and drain the water, engage the blower for about 15 seconds to purge all residual water in the lines. Every three months, we recommend that you fill the tub about two inches over the highest jet with lukewarm water and add a half cup of bleach. Engage the air blower and let run for five minutes. Empty and repeat this step with clean water and finally press the air button to purge the air lines when the tub is empty.
It is safe to use bath salts and bubble bath within the system but just remember that if you use too much bubble bath, the bubbles could really mount up, especially with the water jets on.
Very simple to install.
- Connect flexible water lines from the faucet to supply nipples from the floor.
- Connect drain tail piece to floor
- Plug in a standard 110v - 15 amp plug into a GFCI on the wall. We supply 3' of cable from the tub to the wall.
Take a Closer Look at the SanSiro Air Jetted Vintage Slipper Tub in this Quick Video:
SanSiro Jetted Tubs - Electrical Cord Position on Tub All of the jetted tubs in the SanSiro range use a 3' long cable 110v – 15-amp standard 3 pin plug. You have choices as to where you would like the plug on the jetting system to connect to the GFCI outlet in your home. 1 - Leave the connection under the tub. In this case, you would need to have your GFCI at the control board and not on the plug under the tub. 2.- Connect to a wall socket GFCI. You can drill holes in the outside of the tub and run the electrical cable to a wall mounted GFCI near the tub. 3 - To drill the holes, we recommend first drilling the 1/8” (bit supplied) pilot hole and then the hole saw supplied. If you have two plugs, drill two holes. 4 - You can then feed the cord through the hole(s) and attach the rubber grommet. This grommet fits around the inside of the hole to prevent a rough tub edge rubbing on the electrical cord. Just in case you need it, we include an additional 3’ long extension cord for each plug on the tub. See or print photo directions
|
|
 |
 |
 |
 |

|