SanSiro Jetted Tubs - Electrical Cord Position on Tub

All of the jetted tubs in the SanSiro range use a 3' long cable 110v – 15-amp standard 3 pin plug. You have choices as to where you would like the plug on the jetting system to connect to the GFCI outlet in your home.
1 - Leave the connection under the tub. In this case, you would need to have your GFCI at the control board and not on the plug under the tub.
2.- Connect to a wall socket GFCI. You can drill holes in the outside of the tub and run the electrical cable to a wall mounted GFCI near the tub.
3 - To drill the holes, we recommend first drilling the 1/8” (bit supplied) pilot hole and then the hole saw supplied. If you have two plugs, drill two holes.
4 - You can then feed the cord through the hole(s) and attach the rubber grommet. This grommet fits around the inside of the hole to prevent a rough tub edge rubbing on the electrical cord.
Just in case you need it, we include an additional 3’ long extension cord for each plug on the tub.
See or print photo directions