SanSiro 'Augusta67EAJ' 67 x 34 inch End Drain HEATED AIR JETTED High Gloss White ACRYLIC Freestanding Bathtub
Ready to plug in to a 15 amp 110 v GFCI
Photo here shows 67" version of the tub, proportions may change a little on different length tubs
Made in the USA, the SanSiro 'Augusta67EAJ' is a fabulous minimalist style oval hot air jetted acrylic bathtub.
Soothe away the aches of the day in a luxurious heated air
jetted bathtub. We offer variable speed handheld remote control blower
activation. There are 14 individual flat face air injectors, 8 on the floor, 4 at the back and 2 at the feet to massage calves, thighs, feet and back. We use a heated blower to increase the ambient
temperature of the bubbles 15 to 20 degrees within a period of around 2
minutes. Switching the air jetting on before entering the tub can be a good
idea. While the air is heated, it can still feel slightly cool when the bubbles
touch the skin, it will not feel hotter than the water in the tub.
To maintain hygiene in the air pipes, every time you take a bath and drain the
water, engage the blower for about 15 seconds to purge all residual water in
the lines. Every three months, we recommend that you fill the tub about two
inches over the highest jet with lukewarm water and add a half cup of bleach.
Engage the blower and let run for two minutes. Empty and repeat this step with
clean water and purge the lines when the tub is empty.
and sides of the tub are specially fiberglass and resin coated and the air
cavity in between the inner and outer shells acts as a natural heat loss
barrier. We have conducted tests with a foam filled cavity instead of air and
there is no improvement on heat retention.