To maintain hygiene in the air pipes, every time you take a bath and drain the water, engage the blower for about 15 seconds to purge all residual water in the lines. Every three months, we recommend that you fill the tub about two inches over the highest jet with lukewarm water and add a half cup of bleach. Engage the air blower and let run for five minutes. Empty and repeat this step with clean water and finally press the air button to purge the air lines when the tub is empty.
SanSiro Jetted Tubs - Electrical Cord Position on Tub
All of the jetted tubs in the SanSiro range use a 3' long cable 110v – 15-amp standard 3 pin plug. You have choices as to where you would like the plug on the jetting system to connect to the GFCI outlet in your home.1 - Leave the connection under the tub. In this case, you would need to have your GFCI at the control board and not on the plug under the tub.2.- Connect to a wall socket GFCI. You can drill holes in the outside of the tub and run the electrical cable to a wall mounted GFCI near the tub.3 - To drill the holes, we recommend first drilling the 1/8” (bit supplied) pilot hole and then the hole saw supplied. If you have two plugs, drill two holes.4 - You can then feed the cord through the hole(s) and attach the rubber grommet. This grommet fits around the inside of the hole to prevent a rough tub edge rubbing on the electrical cord.Just in case you need it, we include an additional 3’ long extension cord for each plug on the tub.See or print photo directions