Soothe away the aches of the day in a
luxurious heated air massage bathtub. We offer variable speed handheld remote
control blower activation. The 12 individual flat face air injectors are placed
on the bottom of the tub to massage calves and thighs. We use a heated blower
to increase the ambient temperature of the bubbles 15 to 20 degrees within a
period of around 2 minutes. Switching the air jetting on before entering the
tub can be a good idea.
While the air is heated, it can still feel slightly cool when the bubbles touch
the skin, it will not feel hotter than the water in the tub.
Installation on this tub is very simple,
everything needed is part of the tub. Simply connect the regular 3-pin plug to
a 110v-15amp GFCI and you're ready to go. The blower is inside the pedestal. In
the unlikely event of a blower failure, replacing it is also very simple, just
disconnect the electric and tub from the drain, turn it over and replace the
blower, about a 30-minute job.
To maintain hygiene in the air pipes, every
time you take a bath and drain the water, engage the blower for about 15
seconds to purge all residual water in the lines. Every three months, we
recommend that you fill the tub about two inches over the highest jet with luke-warm
water and add a half cup of bleach. Engage the blower and let run for two
minutes. Empty and repeat this step with clean water and purge the lines when
the tub is empty.